Aniline-formaldehyde resin at 120 ° C for 16 hours curing the
thermal deformation temperature of 155 ° C
Phenol-formaldehyde resin was cured at 180 ℃ 2 hours
Curing a curing agent for the type of accelerator and the applicable
Phenol applicable curing agent: amine curing agent
Apply a curing agent of a bisphenol A: an amine curing agent
Resorcinol applicable curing agent: amine curing agent
DMP-30 HY960 i.e. 2,4,6 - tris (dimethylaminomethylene meth) a
curing agent for phenol: amines, acid anhydrides, low molecular
weight polyamide-based curing agent
DMP-10, i.e. a curing agent for dimethylaminomethyl phenol: amines,
acid anhydrides, low molecular weight polyamide-based curing agent
Pyridine applicable, curing agent: acid anhydrides, low molecular
weight polyamide-based curing agent
Benzyldimethylamine applies the curing agent: acid anhydride type
curing agent. DY 062 proportion of 0.895-0.9 g / cm 3 Viscosity 25 °
C <10 cps flash point 33-37 ℃
2 - ethyl-4 - methylimidazole curing agents applicable: acid
anhydrides, dicyandiamide type curing agent
Boron trifluoride - monoethylamine apply curing agent: The amine
curing agent
A curing agent for triethylamine: anhydride-based curing agent
Fatty amines applicable curing agent: low-molecular weight polyamide
curing agent
Between the cresol applicable curing agent: amine curing agent
Triethanolamine of a curing agent for: an amine curing agent
The ethanedithiol applicable curing agent: amine curing agent
Nonylphenol applicable curing agent: amine curing agent
The triethyl amine borate applicable curing agent: amine curing
agent
The acylguanidine applicable curing agent: dicyandiamide type curing
agent
Salicylic acid metal salts - amines (such as zinc salicylate -
isopropylamine proportion of 2:1, and an amount of 5% of the resin)
of the curing agent to be applied: an amine curing agent
Salicylic acid - boron complex is obtained by 2 mole of salicylic
acid and 1 mole H3BO3 system, 2C6H4 (OH) COOH + H3BO3 = (OC6H4COO)
2BH +3 H2O the salicylic acid - boron complex polyethylene II
alcohol 600 formulated as a 66.2% solution, to the accelerator not
only shorten the gel, the curing time, but also increases the heat
resistance temperature. Apply a curing agent: 10% of the amine
curing agent solution is an amount of resin
Over benzoyl peroxide apply a curing agent: diamino diphenyl methane
Salicylaldehyde cobalt apply a curing agent: 1-1.5% of an amount of
resin in the acid anhydrides
